can't connect to MP277-10 touch with ethernet

hi

iam new here and i need help

my IHM MP277-10 touch  was damaged and i have new one and i can't transfer Wincc project using ethernet cable.

plz help me

Best regards

Hi,

have the Panel a valid IP Adress and can you ping the Panel from you PC?
Is the transfersettings on the panel configured for transfer with ethernet?

Regards
Christoph

hi

no there is no ip adress

can u help me to find ip adress

the transfer setting are configured with ethernet but iam not sure if the adess ip is correct

thnx

Hello,

in the settings of the panel you can configure a IP for this panel (Netwrok settings).
Configure here the IP Adress.

Here 2 FAQ's for the settings:

https://support.industry.siemens.com/cs/ww/en/view/88633853

https://support.industry.siemens.com/cs/ww/en/view/23800567

Regards

Christoph

hi

thnx for ur useful informations

i read the documents

i have problem with IP adresse in IHM Panel....... how can i choose it........... the IP in the document is it the right one ??

thnx for help

best regards

Hi,

i don't understand the question.

The IP you must choose is your part you must say which is the right one.

Is there no ip in the project specified for the panel?

The adresss in the document is valid for the described procedure in the document,
but not for your Panel on your place.

Regards

Christoph

hi

yes there is no ip adresse in the project .

Hello, 

Choose unique IP address of your network.

For example, if your PC IP address is: 192.168.0.1, select address of MP 192.168.0.X; X is a un used address. 

Hope this helps. 

hi

i understand now

thnx a lot ayman and christoph

best regards

Hello,

ok, which IP Have the PLC?
You should set a ip on the panel which is in the same subnet like the PLC so that after the download a connection can be established.

Regards

Christoph