Navigation

Converting ToolBox Library LCON works with CU250S

Created by: AutoGen_8058858 at: 11/27/2019 6:38 PM (1 Replies)

11/27/2019 6:38 PM	Rate (0)
AutoGen_8058858 Posts: 1 Rating: (0)	Hi! I need to control 2 winders with a CU250S-2 PN cpu and the PM240-2 power unit, but I need to know if the converting toolbox (LCON) library would work with that CPU or should I use a CU310 or CU320 cpu. Thanks.
AutoGen_8058858 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

11/29/2019 10:28 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 10/30/2024 Posts: 5933 Rating: (815)	Hello, are you planning to use the SIMATIC library LCon to control the two winders or are you planning to run it in the drive? A description of all winder applications can be found under the following link: https://support.industry.siemens.com/cs/de/en/view/109744606 For SIMATIC it depends on your control mode (torque or speed controlled) and the type of controller (S7-1200 without technology objects / S7-1500 using technology objects). A description of the different solutions for SIMATIC can be found under the following link: https://support.industry.siemens.com/cs/attachments/58565043/2019_10_14_Detailed_Comparison_of_Winding_Tension_Control_Solutions.pdf
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer