Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HSC and SFB47

Created by: Oscar_83PL at: 5/13/2009 3:21 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

5/13/2009 3:21 PM	Rate (0)
Oscar_83PL Bronze Member Joined: 10/22/2008 Last visit: 10/14/2024 Posts: 369 Rating: (5)	Hello I can't make my HSC count. HW setting: AddressIO-768...783 channel 0 count continously signal evaluation- pulse/direction HW gate: none SFB47 in OB1: Laddr: 16#300 channel:0 sw gate: true Countval:MD10 I apply impulses from switches because i wait for encoder. The problem is that OUT countval desn't change it's value. Did i forget about something? thanks for any help. best regards
	Last edited by: Oscar_83PL at: 5/13/2009 3:22 PM
Suggestion To thank Quote Answer

5/13/2009 3:30 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/6/2024 Posts: 8768 Rating: (1170)	Dear Oscar_83PL, You have your puls on DI + 0.0 and the direction will be on DI + 0.1 This mean only DI + 0.0 will change. (Do you count in one direction? (Only up)) Please be aware of DI + 0.1 Best regards, Wizard

Suggestion To thank Quote Answer

5/13/2009 3:38 PM	Rate (0)
Oscar_83PL Bronze Member Joined: 10/22/2008 Last visit: 10/14/2024 Posts: 369 Rating: (5)	For now i don't really care if it counts up or down. I have 2 switches first in DI0.0(22) DI0.1(23). When i switch DI0.0 nothing hapens, when i hold DI0.1 and switch DI0.0 also nothing hapens.

Suggestion To thank Quote Answer

5/13/2009 3:44 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/6/2024 Posts: 8768 Rating: (1170)	Dear Oscar_83PL, You use connector 22 and 23 . Shouldn't it be connector 2 and 3. Best regards, Wizard

Suggestion To thank Quote Answer

5/13/2009 3:50 PM	Rate (0)
Oscar_83PL Bronze Member Joined: 10/22/2008 Last visit: 10/14/2024 Posts: 369 Rating: (5)	I have 6es7 313 5bf03 0ab0 Sure, you are right, a i messed up DI connectors. DI+0 was on next rail. Probably i sit on thos a little to long. Thank you very much.
	Last edited by: Oscar_83PL at: 5/13/2009 3:55 PM
Suggestion To thank Quote Answer

5/13/2009 3:56 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/6/2024 Posts: 8768 Rating: (1170)	Dear Oscar_83PL, I think you use wrong connector. Please have a look at this manual: http://support.automation.siemens.com/WW/view/en/12996906 See chapter 7.6. You should use most right connector. Best regards, Wizard
	Last edited by: Wizard at: 5/13/2009 3:57 PM You already found it. ;-)) I hope it will work now.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on