Insufficient memory on the memory card

Hi everyone,

I've got the following problem:

when I try to load program PLC gives error:
"insufficient memory on the memory card for this amount of data"
I use 4Gb Siemens SD card for CPU 1215SP F-1 PN

Te question is that I can load HW separately, but when I try to load Software I got the error and then available amount of memory on diagnostics rises to 76% (does not depend on download program size)

+I tried to ldownload blocks separately and got the same error;

+I tried to load program straight to SD but it did not work;

+I checked program size and it is only about 3.5MB- so it sutes the card;

+I formated card in TIA portal in order to clear it;

What is the problem and how can I solve it?

Hi Nikita.

1. Please provide some screenshot of the problem

2. I think the problem is elsewhere.

3. Try regular upload-download process.

4. S7-1200 does not need a SD card for program upload or download.

5. Go for a new project, try again and see what happens.

RATE IT. IF IT HELPS YOU.

New question published by AutoGen_3968589 is split to a separate thread with the subject S7-1500: Insufficient memory on the memory card .

Best regards
The Helping Hand