IOT2040 and Siemens RF1060R

Hello together.

I have a RF10060R RFID Reader with a USB Interface.

It looks like that inside is a Baltech RFID Reader.

When i connect the Reader to the 2040 it will be registratet (lspci is ok and i have /dev/USB/hiddev0) but i get no data from the device.

The c# example on a win10 machine is Running without probs.

Does anyone have any advantage for me to get the Reader Running with the iot ?

thx

Hi tomatensaft,

have you found a solution for this? I would like to read the RF1000 with node.js.

Best regards!

Hello,

I have tried Serial Communication with Hyperterminal ( ASCI/RTU protocol) simulator software over RS232 and RS485 interface  of IoT 2040 and its working fine. 

Can you provide mode details of Reader and your serial communication node red configuration?

 hi DJ_1,

I want to know did you tried the serial communication with hyperterminal simulator ? and how did you do it ? can you share some more details with me . thank you so much

best regards

DJ_1

Hello,

I have tried Serial Communication with Hyperterminal ( ASCI/RTU protocol) simulator software over RS232 and RS485 interface  of IoT 2040 and its working fine. 

Can you provide mode details of Reader and your serial communication node red configuration?

Hello,

Yes, I tried with only Hyperterminal on RS232 as well RS485. 

You have to use serial node for the configuration and select the actual interface by click on the node configuration. If time permit then i will make setup again and send pic to you. But its simple. just try out.