Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Motor protection Sinamics V20

Created by: wellzbt at: 2/14/2022 8:06 PM (2 Replies)

Rating (2)

Thanks 0

3 Entries

2/14/2022 8:06 PM	Rate (0)
wellzbt Member Joined: 1/20/2022 Last visit: 2/14/2022 Posts: 1 Rating: (0)	Good afternoon. I have a little doubt, I have a bore water pump, already all programmed to work ok, but I need some kind of protection to run out of water, I tried by temperature but then does not restart the error F11, please someone helps me
	Last edited by: wellzbt at: 02/14/2022 20:07:00
Suggestion To thank Quote Answer

2/15/2022 9:54 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/8/2024 Posts: 5935 Rating: (815)	Hello wellzbt, please check out chapter 5.6.2.9 of the V20 operating instruction manual. https://support.industry.siemens.com/cs/ww/en/view/109799545 There you can find information about load torque monitoring functions, which you can use for realizing no-load monitoring or similar functions.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

2/16/2022 12:24 PM	Rate (2)
Tractor Gold Expert Joined: 3/27/2008 Last visit: 11/11/2024 Posts: 1146 Rating: (142)	The V20 manual does not give a good instruction for load monitoring, and because the MM440 is using the same parameter numbers I have attached a drawing for 'load monitoring', which should give you an idea of what is going on. Come back if I can help further with this. https://cache.industry.siemens.com/dl/files/529/24294529/att_77514/v1/440_OPI_24294529_en_1006.pdf page 223 refers. Tractor Attachment Load monitoring.pptx (476 Downloads)
	Last edited by: Tractor at: 02/16/2022 12:33:11 Last edited by: Tractor at: 02/16/2022 12:57:27 Tractor
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_V

Follow us on