Industry Online Support
Technical Forum
Navigation
Replaced Encoder cable & control card but Error 2 remain
Created by: HaritLalu at: 10/1/2020 1:34 PM (2 Replies)
Rating 
Thanks 0
3 Entries
| 10/1/2020 1:34 PM | |
|
Posts: 1 Rating:
|
Hello, see the attachment, Error 2 is coming after control on, i have replaced Encoder cable & also control card 6SN1118-0AA11-0AA0, But Error 2 remain same. Sir, it is possible to defect in motor encoder ?? my servomotor is 1FT5108-1AC71-1AA0, 1 FU1050-6MC Please guide me. Harit Thakar ------------------------------------------------------------------------------------------ |
Last edited by: HaritLalu at: 10/01/2020 13:36:27Last edited by: Jen_Moderator at: 10/02/2020 09:29:57New subject after splitting |
|
| 10/6/2020 5:35 AM | |
Joined: 10/17/2007 Last visit: 11/11/2024 Posts: 4072 Rating:
|
You need to find a servo motor repair shop to repair your motor.--you motor "rotor position detector" defective or lost alignment Or If I were you , I will search online to buy a used motor
|
|
If you like my comments please |
|
Follow us on