Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S120 PM340 on 230V

Created by: Simotion at: 9/18/2009 10:32 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/18/2009 10:32 PM	Rate (0)
Simotion Posts: 223 Rating: (1)	Is it possible (just for testing applications) drive a motor on an S120 CU310 with PM340 that has an infeed of 230V? There will be no load connected to the motor. I already did it on a masterdrive motion control where I had to set a specific parameter; Is there a parameter to be set on the CU310 so that I can run the motor on 230 V? Thanks
Simotion Posts: 223 Rating: (1)
Suggestion To thank Quote Answer

9/21/2009 12:08 PM	Rate (0)
Graeme Platinum Member Joined: 6/4/2008 Last visit: 3/20/2023 Posts: 1419 Rating: (314)	Hi, Set P0210 to 230V Don't forget to check the motor wiring method (star or delta) Cheers.

Suggestion To thank Quote Answer

9/21/2009 4:25 PM	Rate (0)
Simotion Posts: 223 Rating: (1)	The motor is a servomotor 1FK7, I hope that won't cause me any trouble
Simotion Posts: 223 Rating: (1)
Suggestion To thank Quote Answer

9/22/2009 7:58 PM	Rate (0)
Drives_Coach Posts: 133 Rating: (12)	Hello, I believe I tried one time to see if a PM340 (SINAMICS S120 blocksize AC drive) with a 3phase 380..480 VAC rating would operate on a 3phase 230VAC supply and it would not power up even with an external 24VDC supply. What kW rating are you looking for there is a single phase 230VAC PM340 product range. For higher kW needs I have used the S120 booksize units on 3 phase 230VAC. There are some post on how to do this on this forum. Hope this helps and let us know what you figure out.
Drives_Coach Posts: 133 Rating: (12)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on