S7-1200 Using analog input values to switch outputs.

Hi

I have a logo project which I'm trying to replicate using a S7-1200 where I control 2 pumps dependent on well level, level sensor is a 0-5m (4-20ma) (using a 500ohm resistor on a 1212c to cahnge to V)

I have worked out all my digitals but got stuck on the analogs. 

I have used the norm x - scale x to take the values 0-27648 to 0-5000.

From there I would like to turn Q0 on at 700mm, off at 100mm and Q1 on at 800mm off at 100mm. Just not to sure how to proceed

Any help would be great

Shaun

Which TIA Version use you?

On which analog input is the Signal? On first AI?