Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S71214C and CM1241 no diag.

Created by: Claus Lind at: 3/28/2015 3:28 PM (3 Replies)

Rating (0)

Thanks 2

4 Entries

3/28/2015 3:28 PM	Rate (0)
Claus Lind Posts: 31 Rating: (1)	I am having problems getting diag. status from the SM1241 module in tia portal 13 using a 1214DC The diag led on the 1241 module is green but in the portal it sayes "low level error" and a gray question mark. Is the module faulty (brand new) or ? Best regards Claus Lind
Claus Lind Posts: 31 Rating: (1)
Suggestion To thank Quote Answer

4/1/2015 6:29 AM	Rate (0)
BALAKRISHNAN92 Silver Member Joined: 10/21/2013 Last visit: 9/19/2024 Posts: 417 Rating: (28)	check for event id and help on texi in the diag... have u configured and is the communication is occuring in cm1241....

Suggestion To thank Quote Answer

4/3/2015 12:50 PM	Rate (0)
Claus Lind Posts: 31 Rating: (1)	The CM module has been configured in TIA but when i use TIA to se the diag status it sayes that a low level error has accured. Best regards Claus
Claus Lind Posts: 31 Rating: (1)
Suggestion To thank Quote Answer

4/5/2015 5:24 PM	Rate (0)
Claus Lind Posts: 31 Rating: (1)	Found the fault. CM1241 firmware ver. 2.03 Tia firmware ver. on CM1241 2,1 Changed Tia to 2,03 then ok
Claus Lind Posts: 31 Rating: (1)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users 0_Einstein Min_Moderator

|

Share this page:

Share this page on...

Follow us on