Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Simple progamming question

Created by: Jambo at: 3/26/2011 11:28 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/26/2011 11:28 AM	Rate (0)
Jambo Posts: 13 Rating: (0)	Hi Folks, I have 8 inputs and 4 outputs, 4inputs switch on the coils and 4 switch off the coil through a SR flipflop (relay). Only one coil can run at anyone time and when one coil is switched off the next in line is switched on. Also ifone off the inputs to switch on a coil is activated then that coil takes priority. My problem is if more than one input to switch on a coil is activated then no coils are on! What I want is for the coil with the lowest number to run for a time before the next coil that has the input signal state 1 to run until all coils have run. I have tried to attach my program without any success. With LOGO it was possible to save it in my pictures then the file could be sent.
Jambo Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

3/26/2011 2:17 PM	Rate (0)
Marko Bursic Platinum Member Joined: 9/8/2009 Last visit: 3/15/2023 Posts: 1410 Rating: (148)	You want to make a sequence of steps? I dont't fully understand your question. Use windows functions press Ctrl+PrtSc and then open Accessories->Painter press Ctrl+V and save as .jpg file.

Suggestion To thank Quote Answer

3/28/2011 2:25 AM	Rate (0)
Ayman Elotaify Platinum Member Joined: 5/28/2008 Last visit: 6/4/2023 Posts: 4448 Rating: (827)	Jambo Hi Folks, I have 8 inputs and 4 outputs, 4inputs switch on the coils and 4 switch off the coil through a SR flipflop (relay). Only one coil can run at anyone time and when one coil is switched off the next in line is switched on. Also ifone off the inputs to switch on a coil is activated then that coil takes priority. My problem is if more than one input to switch on a coil is activated then no coils are on! What I want is for the coil with the lowest number to run for a time before the next coil that has the input signal state 1 to run until all coils have run. I have tried to attach my program without any success. With LOGO it was possible to save it in my pictures then the file could be sent. HelloJambo, I am not sure that I have understand your question correctly. For each coil (output) you have two different inputs. One for set and the other for reset the flipflop. Only one coil can run at any time. If coil 1 is being set and then being reset, the next output will not being set until the set input is triggered. So to do the above, you have to add an enable bit for each output in its set condition. In case of more than one set input is active, then the enable bit of the lowest number should be set, then its coil will be energized. If I understand your problem correctly, please see the attached pictures. Hope this helps. Attachment ex.zip (177 Downloads)
	Ayman Elotaify
Suggestion To thank Quote Answer

3/28/2011 7:41 PM	Rate (0)
Jambo Posts: 13 Rating: (0)	Thanks Guys for Help. I will get back to you soon Chris
Jambo Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on