SINAMICS S210 - First start alarm fault (30016)

Hello!

We have just installed new Converter Sinamics S210 with Motor Simotics 1FK2208-3AC01-0SA0 and trying commissioning it.

But we have alarm message after switching on. Alarm 30016: Power unit: Load supply switched off(11). I've already check each supply line (Power line 380V and DC line 24V). Everithing is OK!

Voltage is OK, connecting good. 

Despite this, I tried to one button tunning. This also not helped me. 

Pics attached.

Hope on better!

Regrads

Alex

Hi SANNICAP,

see this FAQ:

https://support.industry.siemens.com/cs/de/en/view/109767864

I guess this is exactly what you need to do :)

I've only done 1 project with the 210's. However, it sounds like you have a Line Module? (LM). It has to be enabled, before any of the drives that are attached to it try to run.

If you don't have a line module, IDK??

Hi KFoldesi,

no Line Module for S210 - it is a single drive AC/AC.

The problem is as described in the FAQ and has to do with the wiring of the braking resistor interface.

Hi, Robert!

Thank you! It was really helphul! 

Now everything is OK!

Regards.

Alex