SIP5 and IEC103 (DPS indications)

Hello,

I can't find out how to setup 7SJ82 to send CB or disconnector position in IEC103 protocol as:

intermediate = 00 (0)

open = 01 (1)

close = 10 (2)

disturbed = 11 (3)

Now I can get only open and close positions.

Thanks!

Thanks for your respond!

Well it's my first Siprotec 5 relay and I'm just playing and learning with it on my table now. Please find attachment with screenshots. You can see that if I send turn on command and the position Close wire is disconnected I get COT=20 message only but no COT=12 with DPI=0 as expected. The last screenshot is then Close position wire is connected.

IEC103 address are configured on Communication mapping "Cmd. with feedback".