Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Step 7 Basic and Installed Simatic Software

Created by: adfox83 at: 10/23/2009 12:16 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/23/2009 12:16 PM	Rate (0)
adfox83 Posts: 8 Rating: (0)	Hi, I'm trying to get deeper knowledge of S7-1200, so i'm preparing for the installation of Step 7 Basic. I've got already installed Step7 Proffesional 5.4 Sp4 Hf3 and WinCC Flexible 2008 SP1 and WinCC 7.0 on my computer. Can I install Step7 Basic onto this configuration without breaking anything ? It's important for me, because my laptop has to be ready for anytime call - i don't want a situation when downtime happen and I'll be getting problems with installed software. Regards
adfox83 Posts: 8 Rating: (0)
Suggestion To thank Quote Answer

10/23/2009 1:09 PM	Rate (0)
Darius Platinum Expert Joined: 9/28/2005 Last visit: 11/5/2024 Posts: 2957 Rating: (242)	Hi, I had the same situation like you and no problems after installing Step-7 basic. You should not be affraid because both is Siemens software and it will be surely compatible.
	Best regards, Darius
Suggestion To thank Quote Answer

10/23/2009 1:53 PM	Rate (0)
adfox83 Posts: 8 Rating: (0)	Ok, thanks for that - i'll try. But Installing for example WinCC 5.1 and WinCC 6.2 together makes a mess in the system :)
adfox83 Posts: 8 Rating: (0)
Suggestion To thank Quote Answer

10/23/2009 2:14 PM	Rate (0)
Darius Platinum Expert Joined: 9/28/2005 Last visit: 11/5/2024 Posts: 2957 Rating: (242)	Yes, but this is other case
	Best regards, Darius
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on