Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA Unified Simulation Partly running

Created by: Wayse2 at: 2/2/2023 2:50 PM (4 Replies)

Rating (0)

Thanks 2

5 Entries

2/2/2023 2:50 PM	Rate (0)
Wayse2 Joined: 11/24/2022 Last visit: 9/15/2023 Posts: 12 Rating: (0)	Hello everyone, i am using TIA/ Wincc Unified v17 Update 5 . i cannot start the simulation for the Unified what so ever. it goes from starting to Partly started . tried : running TIA ,Runtime Manager , WinCC Unified Configuration as Administrator configuring the unifed again with the WinCC Unified Configuration tool, using new certificate, password encrypted transfer . Repaired Tia/WinCC installation . till now nothing helped . Attachment Anmerkung 2023-02-02 154908.jpg (123 Downloads)

Suggestion To thank Quote Answer

2/2/2023 3:02 PM	Rate (0)
Stefan Arcularius Platinum Expert Joined: 1/21/2013 Last visit: 9/22/2023 Posts: 2052 Rating: (312)	Hi Wayse2, this is probably due to an error in your project. You can try to find the error using the TraceViewer. Kind regards Stefan

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Wayse2

2/2/2023 3:12 PM	Rate (0)
Wayse2 Joined: 11/24/2022 Last visit: 9/15/2023 Posts: 12 Rating: (0)	i think the Problem is not with the Project because my colleague is using the same project and Simulating it on his PC. but traceviewer might help to localise the problem .

Suggestion To thank Quote Answer

2/2/2023 8:14 PM	Rate (0)
rdoliveira Gold Expert Joined: 4/26/2012 Last visit: 9/21/2023 Posts: 1373 Rating: (133)	Wayse2 Hello everyone, i am using TIA/ Wincc Unified v17 Update 5 . i cannot start the simulation for the Unified what so ever. it goes from starting to Partly started . tried : running TIA ,Runtime Manager , WinCC Unified Configuration as Administrator configuring the unifed again with the WinCC Unified Configuration tool, using new certificate, password encrypted transfer . Repaired Tia/WinCC installation . till now nothing helped . Hello, take a look at the link in this post. LINK good luck.
	Last edited by: rdoliveira at: 02/02/2023 20:16:38 "Always make a backup before and check the best time before testing." Obrigado.
Suggestion To thank Quote Answer

9/7/2023 2:36 PM	Rate (0)
Roget_K Joined: 8/26/2023 Last visit: 9/19/2023 Posts: 1 Rating: (0)	Hi， I also went through a similar problem and solved it with the help here. My problem in a nutshell is that the name of the computer is inconsistent with the name of the user name. The name on the system information is A, but the user in the Siemens TIA Engineer group in computer management is B. When setting up the certificate in the WinCC Unified Certificate Manager, the name A on the system information needs to be entered. I changed the name A on the system information to the name of user B in computermanagement. Then re-install the certificate on WinCC Unified Certificate Manager. The problem seems to be solved.Simulation is OK.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Stefan Arcularius

|

Share this page:

Share this page on...

Follow us on