Navigation

When starting simulation screen show: "simulation failed to start"

Created by: dinsss at: 7/23/2018 12:27 PM (1 Replies)

7/23/2018 12:27 PM	Rate (0)
dinsss Posts: 6 Rating: (0)	my previous version was v13 and updated in v14, when i started simulation screen show. 1. simulation failed to start . 2. simulation could not be created. let me help out of this. ------------------------------------------------------------------------------------------ Split from about SIEMENS PLC.
dinsss Posts: 6 Rating: (0)	Last edited by: Jen_Moderator at: 7/23/2018 2:01:47 PM New subject after splitting
Suggestion To thank Quote Answer

7/23/2018 3:51 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 11/19/2024 Posts: 15406 Rating: (2446)	Did you install V14 PLCIM? If you did, might I suggest upgrading to V14 SP1? I recall reading on these forums some people had problems with PLCSIM V14, but after installing V14 SP1, problems went away. dinsss my previous version was v13 and updated in v14, when i started simulation screen show. 1. simulation failed to start . 2. simulation could not be created. let me help out of this. ------------------------------------------------------------------------------------------ Split from about SIEMENS PLC.
	science guy
Suggestion To thank Quote Answer