Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC communication with S7400H using simatic NCM

Created by: quadri at: 6/5/2012 9:25 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

6/5/2012 9:25 AM	Rate (0)
quadri Posts: 23 Rating: (0)	can any one please tell me the procedure to make communication between S7-400H fault tolerant system and WinCC V7.0. i have a stand alone PC with single CP1613 CARD and with Simatic NCM manager( no simatic manager). i tried already with the FAQ present online but i could not do it.
quadri Posts: 23 Rating: (0)
Suggestion To thank Quote Answer

6/5/2012 10:10 AM	Rate (0)
April Posts: 1776 Rating: (95)	Hi, you need the S7-Redconnect see /tf/WW/en/Posts/256
April Posts: 1776 Rating: (95)
Suggestion To thank Quote Answer

6/5/2012 10:13 AM	Rate (0)
quadri Posts: 23 Rating: (0)	i have installed redconnect as well in the PC. but still when i open the step-7 project(project created in simatic manager and retrieved from other pc) i am not able to edit in netpro. im getting a message that "the project is write protected"
quadri Posts: 23 Rating: (0)
Suggestion To thank Quote Answer

11/12/2015 2:50 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by AutoGen_203141 is split to a separate thread with the subject How can I access the program which has been downloaded on this PC via NCM manager?. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

WinCC Communication (OPC, S7, OtherSystem)

Follow us on