Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SIMATIC WinCC Audit Viewer 2008 can't read CSV file

Created by: ctleng98 at: 10/4/2022 6:59 AM (2 Replies)

Rating (1)

Thanks 0

3 Entries

10/4/2022 6:59 AM	Rate (1)
ctleng98 Member Joined: 6/4/2021 Last visit: 5/23/2024 Posts: 2 Rating: (1)	Hi experts, I am facing this issue when I am select the CSV file generated by Audit Trail. The HMI selection I used was TP1500 comfort. I had tried to change the Regional settings and delimeter of the CSV file, but the issues is still there. This 2 solution was found from other forum. The error message pop up was shown below: The audit trail file was selected. After that, I clicked ok will pop up this error Next, when I exit the browse window will pop up this error Lastly, it will pop up this error

Suggestion To thank Quote Answer

10/4/2022 7:04 AM	Rate (0)
KLCY62 Member Joined: 6/16/2022 Last visit: 10/5/2022 Posts: 2 Rating: (1)	Wish to know the solution too

Suggestion To thank Quote Answer

10/4/2022 12:55 PM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 11/13/2024 Posts: 14165 Rating: (1774)	Hello I would say, check this FAQ: https://support.industry.siemens.com/cs/ww/en/view/109795515 It is not alowed to change the audit File this is against the GMP rules. At Comfort Panels there are regional settings with specific delimiter. The same you have to set in your Windows regional Settings to open the Audit file in the viewer properly Bye Murof
	Last edited by: Murof at: 10/04/2022 12:58:07 If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on