Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Copy of Protool

Created by: AutoGen_1051881 at: 8/15/2015 7:21 AM (2 Replies)

Rating (0)

Thanks 1

3 Entries

8/15/2015 7:21 AM	Rate (0)
AutoGen_1051881 Posts: 1 Rating: (0)	Hello Aymen Elotaife, I hope you are fine. Dear i need Pro Tool CS to upload data from operator Panel OP170b installed at my plant. could you please give a copy of the software? Email me your reply. i'll be waiting for it from now on. Regards Asad Butt ------------------------------------------------------------------------------------------ Split from Protool on Windows 7 Ultimate 32-bit.
AutoGen_1051881 Posts: 1 Rating: (0)	Last edited by: Min_Moderator at: 8/17/2015 1:43:48 PM New subject after splitting and delete contact data
Suggestion To thank Quote Answer

8/15/2015 9:05 AM	Rate (0)
Ste39 Platinum Member Joined: 1/21/2013 Last visit: 10/23/2024 Posts: 4620 Rating: (708)	AutoGen_1051881 Hello Aymen Elotaife, I hope you are fine. Dear i need Pro Tool CS to upload data from operator Panel OP170b installed at my plant. could you please give a copy of the software? my email address is axadbutt@live.com. Email me your reply. i'll be waiting for it from now on. Regards Asad Butt Dear Asad Butt, I don't think you will have it, You have to go in the nearest Siemens dep.

Suggestion To thank Quote Answer

8/17/2015 2:18 PM	Rate (0)
ChristophD Grandmaster Joined: 5/12/2006 Last visit: 11/14/2024 Posts: 22452 Rating: (3029)	Hello, and note that a upload is not possible for HMI device! You need the original project from the engineering station! Regards Christoph

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Ste39

|

Share this page:

Share this page on...

Follow us on