Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

840D Modulo Display

Created by: BobR at: 4/19/2007 11:18 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/19/2007 11:18 PM	Rate (0)
BobR Posts: 11 Rating: (1)	Is it Ok that Machine Screen shows spindle position with 360 Modulo (0-360deg), but diagnostic Service Axis/Drive screens show same position without modulo (0-infinite/rollover)? Bobr
BobR Posts: 11 Rating: (1)
Suggestion To thank Quote Answer

4/20/2007 10:31 AM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear BobR In response, Yes, this condition is acceptable. The spindle is, in fact as rotating axis and is treated as such by the control system. The Modulo display is configured by machine data. Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

4/20/2007 1:50 PM	Rate (0)
BobR Posts: 11 Rating: (1)	Thanks Steve, I was just curious could that somehow be one of the reasons for my problem with 300508 fault (another thread). BobR
BobR Posts: 11 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on