Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Synchronized Actions

Created by: tommyh at: 6/28/2007 10:20 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

6/28/2007 10:20 PM	Rate (0)
tommyh Posts: 2 Rating: (0)	Hi Is it possible to trigger an emergency stop or something else that stops spindle/feed and program execution from an synchronized action? This is on a 840D thanks
tommyh Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/1/2007 1:55 PM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	Hi, I would think there are a few options. You can stop the spindle by issuing an M5 from a sychronous action and you could stop the axis by delete distance to go from the current block and then jumping to the end of the program M30 or an M00 so you can see where the stop occurred.
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

7/4/2007 1:03 AM	Rate (0)
tommyh Posts: 2 Rating: (0)	Thanks for your reply I will give it a try, but the documentation says auxillary functions and delete distance to go must only be programmed in non-modal synchronous actions.. I need it to be a modal action. Pee Ell Sea Hi, I would think there are a few options. You can stop the spindle by issuing an M5 from a sychronous action and you could stop the axis by delete distance to go from the current block and then jumping to the end of the program M30 or an M00 so you can see where the stop occurred.
tommyh Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/4/2007 10:45 AM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	Hi Again, If you have access to the plc then you can program an NCK input to stop the machine andset the input from any type of synchronous action.
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on