Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7-1200 change mode

Created by: kaftaraco at: 7/27/2010 12:22 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

7/27/2010 12:22 PM	Rate (0)
kaftaraco Advanced Member Joined: 7/26/2010 Last visit: 8/23/2024 Posts: 4 Rating: (0)	Hi All I have one question. What is change to PLC mode stop to rum mode by programing mode. For exaple I have one HMI software i conect to PLC by OPC mode i change Run mode to Stop mode my HMI software but i don't change Stop mode to Start mode by my MHI software. The S7-1200 PLC do you have spesial memory bits or spesial adres to change Stop to Run mode.

Suggestion To thank Quote Answer

7/27/2010 1:24 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/1/2024 Posts: 8759 Rating: (1170)	Dear kaftaraco, It is only possible with software Step 7 Basic. Best regards, Wizard

Suggestion To thank Quote Answer

7/27/2010 2:57 PM	Rate (0)
kaftaraco Advanced Member Joined: 7/26/2010 Last visit: 8/23/2024 Posts: 4 Rating: (0)	Dear Winzar Thank you your my replay. I do not understand why is onyl change to start mode by Simatic software

Suggestion To thank Quote Answer

7/27/2010 3:49 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/1/2024 Posts: 8759 Rating: (1170)	Hi, Please have a look at this discussion: /tf/WW/en/Posts/32766 To get it back to run: Power off/on is another possibility. Best regards, Wizard

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on