Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

ET200 SP HA IOs and PLCSIM with PCS7

Created by: DarshanS at: 3/11/2024 7:28 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

3/11/2024 7:28 PM	Rate (0)
DarshanS Experienced Member Joined: 12/3/2010 Last visit: 10/29/2024 Posts: 31 Rating: (1)	I am using ET200 SP HA IOs and CPU 410 - 5H. DUring simulation on PLCSIM I am not able to test as my channel driver does not pass actual input to output. On investigation, i found that PN IO system is not getting enable in @ CHarts. Any Solution or anyone faced such problem.?
	Last edited by: DarshanS at: 03/13/2024 05:44:05
Suggestion To thank Quote Answer

3/13/2024 8:13 AM	Rate (0)
Oreca Platinum Expert Joined: 3/14/2008 Last visit: 11/3/2024 Posts: 2121 Rating: (949)	Hi, With PLCSim, you don't have access to real I/O. You have to set SimOn signal at the driver block to get a value without Bad signal.
	If I could help you, you can use the RATE button. Thank you. Prospact Netherlands...your PCS7 and PCS neo Expert Topic: PCS7 Complete Overview
Suggestion To thank Quote Answer

5/30/2024 4:19 AM	Rate (0)
DarshanS Experienced Member Joined: 12/3/2010 Last visit: 10/29/2024 Posts: 31 Rating: (1)	I do not agree to this. You can very well simulate all IOs with PLC Sim. But for ET200 SPHA Mode values are not transferred. F-AI simulation is working. Oreca Hi, With PLCSim, you don't have access to real I/O. You have to set SimOn signal at the driver block to get a value without Bad signal.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on