Hello everybody

Dear friends

I've wincc2008 installed on my normal PC which has both serial port and usb port

I've PC-Adaptor USB , 6ES7 972-0CB20-0XA0 and MPI cable 6ES7 901-0BF00-0AA0

how can I connect between TP177A 6" ( 6AV6 642-0AA11-0AX1 ) which has only one port IF-1B which can be configured to either RS422/485 or DP/MPI/PPi

and how to adjust to communicate with CPU 314 ( MPI and PROFIBUS )

Many thanks and best regards

Hassan

Thanks friend for your fast reply

I already did it before using PC-Adaptor USB but unfortunately I don.t remember the steps and the used configuration I searched the topics here but till now I don't get the way to do

If possible Please I need your help urgently

Many thanks and best regards

Hassan

Wizard

Dear HassanShahat,

Perhaps this link might help:
http://support.automation.siemens.com/WW/view/en/23802404

Are you connected to HMI panel or is there a CPU in between?

Best regards,

Wizard

Dear friends

thanks alot for your help

Now I get CP5512 Simatic net with PCMCIA to connect through my laptop

I followed the instruction in the topichttp://support.automation.siemens.com/WW/view/en/23802404

exactly and when reading with the read in the "Diagnostics" I get the address set in the TP177A when putting in the transfer

But till now can't transfer the project after setting every thing

I tried the TP177A ( loaded with old application with CPU314 and communication port is working and data is transferred from and to unit with CPU )

Please still need your help

Hassan

HassanShahat

I've wincc2008 installed on my normal PC which has both serial port and usb port

I've PC-Adaptor USB , 6ES7 972-0CB20-0XA0 and MPI cable 6ES7 901-0BF00-0AA0

how can I connect between TP177A 6" ( 6AV6 642-0AA11-0AX1 ) which has only one port IF-1B which can be configured to either RS422/485 or DP/MPI/PPi

and how to adjust to communicate with CPU 314 ( MPI and PROFIBUS )