I am trying to connect the LOGO FS4 to my PC via Ethernet.

The Ethernet connection is good (pinging)

Next, the software (8.2.1) detects de LOGO but a message appears “can’t access to the remote device”

Can anybody help me?

Thaks.

Jay.

 

ixo65

 

Jaya1189

Same here. Even though I was able to communicate between logo and s7-1200 for one sensor with the help of IXO, I am still in doubt about the addressing concepts in PUT and Get and also in Logo and how they identify the address linking with network io. I am still testing many variables in that and couldn't find a fixed solution.

Jay

No solution for you in PM of #dP?

ixo65

Create the connection with the LOGO! as a client and the S7 as a server.

In TIA:
Make sure that in the "Special connection properties" the check mark "Active connection establishment" is removed.
Make sure that in the device view, by the properties of the protection and security (connection mechanisms) the check mark is set for "permanent access for PUT/GET communication from remote partner".

For me it works as stated in the above post by me.
If you want, I will send you my test Project.

 His PM is just the basic settings to be made. Maybe I am not understanding the addressing part which makes my testing not work. Communication betwenb the plc is fine. Just the addressing in LOGO and S7 that's is where it's becoming more complicated for me

Jay

------------------------------------------------------------------------------------------
Split from LOGO! 8 FS4 & S7-1200: Communication doesn't work..

I have similar problem to connect LOGO FS4 (with extra AM2 module) to the PC. The device is pinging but LSC "can't access to the remote device".

I have tested several PCs windows7 and 10 and even linux (ubuntu).

The IPs of the PC and of the LOGO have been setup different ways. Finally the configuration is as fllowing:

Device: 192.168.0.2

Subnet Mask (in LOGO and PC): 255.255.255.0

Geteway (in LOGO and PC): 192.168.0.1

PC: 192.168.0.10

Thanks in advance