SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Not able to do transfer and select PC-> Logo

4/5/2019 4:15 PM	Rate (0)
Joske V Posts: 1 Rating: (0)	Hello, I have purchased new Siemens logo Siemens 6ED1052-1MD08-0BA0 with SD-Card I am working with the latest SW Logo Soft comfort V8:2. Ip address is ok When doing connection test, I see the logo connected, the green V is on on the module in my program. When going to transfer and select PC-> Logo. Following message is always coming up Download PC -> Logo Failed. Than looking into info, same error message is showed, nothing more. Download Logo -> PC is no problem. no errors. What can I do here? Thanks for your support ------------------------------------------------------------------------------------------ Split from With Logo 8.2, I can't transfer the program to the PLC.
Joske V Posts: 1 Rating: (0)	Last edited by: Jen_Moderator at: 4/8/2019 7:08:11 AM New subject after splitting
Suggestion To thank Quote Answer

4/5/2019 4:20 PM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/3/2024 Posts: 34132 Rating: (4250)	Would try to transfer the program only to the LOGO! or to the sd Card in the LOGO!? Please can you upload your Programm as a ZIP file to the Forum?
	Last edited by: ixo65 at: 4/5/2019 4:31:00 PM
Suggestion To thank Quote Answer

4/8/2019 9:40 AM	Rate (0)
AutoGen_380038 Silver Member Joined: 9/11/2014 Last visit: 10/31/2024 Posts: 775 Rating: (33)	Hi, try the following: 1. Before DL to LOGO! press F2 and check the status window. Maybe your program cannot be executed (not connected FB's)). 2. If 1 is fine, disconnect your PC from all Ethernet connections except the Ethernet Interface to LOGO! 3. Start DL to LOGO! and if the information is displayed that .... Subnet ......, then press OK. 'In this case LSC is controlling the Ethernet interface, change as needed and switch back if you close LSC. Be sure LSC is running in Admin mode. Hope this helps

Suggestion To thank Quote Answer

4/8/2019 9:52 AM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/3/2024 Posts: 34132 Rating: (4250)	If you use the program of the LOGO! to the PC, the connection works. Have you ever tried a trial, the same program then back to the LOGO! transferred to? If it works, the problem is with your program, which you can not transfer. It then lacks e.g. a completion for a block, e.g. a function block with an output. If this output is not wired, you will not be able to transfer the program, even if it works in the simulation.

Suggestion To thank Quote Answer

Share this page:

Share this page on...