I want to use different languages for HMI text, but after language change in writes triangles. Can I check font type for each language and is it possible to add/ change font type.

P.S :  I  want to use Georgian  symbols like this : "Hello"  -> "გამარჯობა" 

Hello,

Have you done this? in Language & resources tab >> Project languages >> check Georgian

Then in Language & resources tab >> Project text fill all text field's in Georgian language tab (you don't see triangles no more)

In HMI Runtime settings go to Language & font there you can change font for your languages.

Mr.V

Hello,

Have you done this? in Language & resources tab >> Project languages >> check Georgian

Then in Language & resources tab >> Project text fill all text field's in Georgian language tab (you don't see triangles no more)

In HMI Runtime settings go to Language & font there you can change font for your languages.

 Yes I did same steps as you recommended. I found next : On KTP400( 123-2DB03-0AX0) can not write Georgian font. Maybe I do something wrong....... On TP900 it works without any issue  

And also for other basic panel have same problem!

Mr.V

Did you try to download project? You see triangles in downloaded HMI or in simuliaton mode? It's strange thing, because in TIA project you can use Georgian symbols and write text, but then start simuliator for me show rectangles. 

 yes during simulation it shows rectangles. I have not tested that on real device (unfortunately I do not have that one at office) .