SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Fuse Burning

11/24/2007 1:44 PM	Rate (0)
Kutty Posts: 16 Rating: (0)	Hello, We are using 6RA70D DC Drive for Centrifuge application. IN that particular drive is running at rated speed, suddenly the incomming fuse is gone whilepower failure condition. This is four quadrant dc drive. Is there any parameterization or motor problem?
Kutty Posts: 16 Rating: (0)
Suggestion To thank Quote Answer

11/25/2007 7:10 PM	Rate (0)
atharva Bronze Member Joined: 2/27/2007 Last visit: 3/30/2022 Posts: 79 Rating: (5)	Is fuse blows for every power failure? Sometimes power failure is not sudden switch off but it is ON/OFF 2-3 times with in very less time we can not able to notice it at such condition fuse may blow

Suggestion To thank Quote Answer

11/28/2007 1:34 PM	Rate (0)
Kutty Posts: 16 Rating: (0)	Thanks for your reply. This event happened most of power failure condition.
Kutty Posts: 16 Rating: (0)
Suggestion To thank Quote Answer

11/29/2007 7:52 PM	Rate (0)
human Posts: 26 Rating: (3)	I'v read some manual about 6RA70 "Each time the line voltage is switched on (e.g. by means of a line contactor), the SIMOREG CCP needs approx. 3 secs until it is ready for use again because the commutation capacitors first have to be charged." I'm not an expert but if there is no power the capacitors can't be recharged to be ready.
human Posts: 26 Rating: (3)
Suggestion To thank Quote Answer

1/21/2008 9:23 PM	Rate (0)
Wally05 Posts: 5 Rating: (0)	have had this problem before, especially with DC drives. a phase monitoring relay which cuts out the main switch should help.
Wally05 Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

2/26/2008 12:26 PM	Rate (0)
RAKESH2 Posts: 60 Rating: (2)	Dear Kutty, Blowing of fuse is an uncontrolled phenomena in case of a power failure. Practically DC terminals of motor get shorted through the thyristor of same branches. You will have to provide a High speed DC breaker and may be a choke.This is the only device which can open before the fuse.A cordination study is required between fuses, thyristors and Breaker. This is a costly option.But if the power failures are quite often then you must go ahead with it. Regards Rakesh
RAKESH2 Posts: 60 Rating: (2)
Suggestion To thank Quote Answer

Share this page:

Share this page on...