SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

manual for 880 tt

10/26/2010 1:24 PM	Rate (0)
Import-User-1 Posts: 3609 Rating: (29)	Kalpesh Patel i have sinumerik 880 tt system with five axis and two spindle,i have lot of problem with programming ,please guide me if any manual is available for 880 tt ,for all r parameter and @ command programming,is available for programming ,or please tell me any available software which can simulate my programme ,and my machine read x1=100 instead of x100 is it possible to change x1= to x for simple programming ,because all programmer in india specially in my town is not useto this system ,and i am really disturb due to programming issue
Import-User-1 Posts: 3609 Rating: (29)
Suggestion To thank Quote Answer

10/26/2010 2:34 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello..... Check this document. it may be useful.... Regards, Ekalavya Attachment Programming Guide 1.pdf (146 Downloads)
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

10/29/2010 6:10 PM	Rate (0)
Kalpesh Patel Posts: 4 Rating: (0)	Dear eklavya thanks for manual.but still i face problem with programming with r parameter
Kalpesh Patel Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

10/29/2010 6:18 PM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	Hi, You could probably change the axis names from x1/x2 and z1/z2 to X Z U W but you need to get into machine data. Are you trying to use the Siemens cycles and need the R parameter definitions. Pee
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

10/29/2010 8:05 PM	Rate (0)
Kalpesh Patel Posts: 4 Rating: (0)	i am trying to make program with %mpf and my own cycle like L50 etc... but i want to produce crank shaft on this machine and my product is change after every 50 cycle ,so i think that i need to use r parameter ,so i can make prg. very comfort wat bcaus, i have lot of dimention are same in diffrent crank shaft ,..... and big problem is when i try to make program with simple way like fanuc and other siemens controller ,programm are very hard to understand ,even after i make programming....
Kalpesh Patel Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...