SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

MASTER DRIVE 6SE7031-8EF

3/13/2009 1:34 PM	Rate (0)
granas Regular Member Joined: 3/9/2009 Last visit: 7/31/2024 Posts: 12 Rating: (0)	Dear All, The above Drive is 5 YEARS OLD I have a problem with one IGBT for Blue PHASE blowing after running for some hours approximately 72 Hours . I have checked the Motor and the motor cable all seem to be okay. What could be the cause and the drive is having the same parameters as commissioned, After the above failure i get F027 FAULT. Regards, grana

Suggestion To thank Quote Answer

4/21/2009 3:55 PM	Rate (0)
naga Posts: 101 Rating: (0)	To segregate the problem with drive or with cable/motor which are external to drive , you try to change the out going cables taking care of no direction reversal. If orignal outgoing cables are R,Y, B make it as B,R,Y and then if B phase IGBT fails some thing wrong with cables/output choke/motor . But if III limb ie. Y phase IGBT fails some thing wrong in drive HW like gate control boardfor firing or Hall effect CTs. Also first check whethe the motor is drawing 3 phase balanced loads. regards, Naga
naga Posts: 101 Rating: (0)
Suggestion To thank Quote Answer

4/22/2009 6:19 AM	Rate (0)
diwa Silver Member Joined: 9/20/2006 Last visit: 8/1/2025 Posts: 307 Rating: (97)	You will have to replace both the igbt's of the b-phase and the iGD (driver) board.

Suggestion To thank Quote Answer

5/17/2009 11:50 AM	Rate (0)
granas Regular Member Joined: 3/9/2009 Last visit: 7/31/2024 Posts: 12 Rating: (0)	Dear Naga, Well thank you very much for your advice for changing the sequence, but i had already tried the same and found the same igbt failing, then i changed with a new drive and the problem is solved. But where can i send my igd card for repair or what could be the cost of new igd drive card. if assuming the failure is of igd card. Regards, granas

Suggestion To thank Quote Answer

5/17/2009 11:56 AM	Rate (0)
granas Regular Member Joined: 3/9/2009 Last visit: 7/31/2024 Posts: 12 Rating: (0)	Dear Diwa, Well thank you very much for advicing me for changing both the igbt and the igd drive, well at the moment i have already put up a new drive and no problem to date. can this igd card be repaired or we need to buy a new igd card Regards, Granas

Suggestion To thank Quote Answer

5/22/2009 10:25 AM	Rate (0)
diwa Silver Member Joined: 9/20/2006 Last visit: 8/1/2025 Posts: 307 Rating: (97)	For the repairs you need to contact your nearest siemens service centre and check with them.

Suggestion To thank Quote Answer

Share this page:

Share this page on...