SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Why the motor can rotation?

6/26/2009 9:09 AM	Rate (0)
Boong Posts: 13 Rating: (0)	Dear All, At now I have problem in Masterdrive MC: - Masterdrive MC is cotrol one Syn servor motor (LENZE), the motor have problem, so i change new one, - The new motor (LENZE) is similar the old one. - After I change new motor, I inser parameter on name plate of motor into the masterdrive (V, f, i, momen . . ) - I set P115 = 2 (Calc MotModel). - I start up motor, motor can not rorate () Why the motor can rotation. pls help me. Tks
Boong Posts: 13 Rating: (0)	Last edited by: CS Moderator at: 6/26/2009 12:38 PM new subject after splitting
Suggestion To thank Quote Answer

6/26/2009 12:09 PM	Rate (0)
umencho Diamond Expert Joined: 3/21/2006 Last visit: 3/30/2025 Posts: 10239 Rating: (1183)	Hi Binh, Your issue is not in the right place. You shoud put in new thread in Simovert Masterdrive conference. Anyway, why didn't you follow steps from manual? So From Version V1.30 onwards, automatic motor identification is available. In the case of non-Siemens motors (P095 = 3 or 4), the rating plate data and number of pole pairs have to be entered, and then automatic parameterizing is called with P115 = 1. After exit from the "drive initial start-up" status with P060 = 1, P115 = 2 is set and hence motor identification is selected. The converter must now be switched in within 30 s so that measuring can start. The alarm A078 is set during the 30 s. wrote: The motor shaft can move slightly during the measurement operation. The motor cables are live. Voltages are present at the converter output terminals and hence also at the motor terminals; they are therefore hazardous to touch. First input the motor data, then P115=1 and after P115=2.... More in manual mc24_kompendium (page 141) Hope this will helps. Best regards Hristo Mihalev

Suggestion To thank Quote Answer

6/29/2009 4:54 AM	Rate (0)
Boong Posts: 13 Rating: (0)	Dear Sir, - Tks - Today, I wil try again
Boong Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...