PLC: Climatix POL638.70 with Ethernet TCP/IP on board

SCADA: WinCC V 7.5 SP1

Hello ZHK;

I have no knowledge about your PLC , unfortunately.

Here us the WinCC v7.5 SP1 system manual, with information on communication channels supported by the SCADA system.

https://support.industry.siemens.com/cs/bh/en/view/109773067

See the accompanying screenshot.

If you find no protocol directly supported by your PLC, is there a possibility of an OPC server, this is often a possible solution to bridge a missing driver.

Hope this helps,

Daniel Chartier 

Dear forum member,

The Climatix controller range is sold to OEM partners only, so far as I know. You should contact the support organization of this partner to get detailed information about the application loaded in the controller. The application may have an impact on the integration options. You normally have to define the DPs provided in the communication interface. This is done in the application.

The POL638.70 is also sold with the District Heating standard application. In case you should have this standard DH1 V1.2x application, you have two options for the integration. You can integrate this application via Modbus or BACnet. For Modbus you need an additional Modbus RTU to Modbus IP gateway. For BACnet you need an additional BACnet communication module POL908.

As WinCC V7.5 SP1 does not support BACnet (WinCC OA does) you may want to use Modbus.

Please contact the local OEM partner for the MODBus mapping for the DH1 V1.2x application and for any further questions you may have.

Best regards,

Albis

Hi,

Directly out of the climatix controller is not possible, There has to be a interface protocol.

It can be done with bacnet or opc e.g.

For bacnet a seperate pol 90x communicationmodule is needed. The bacnet points have to be added to objectmapping file in controller.

OPC you will need the remoteopc software. A license is needed to run this software.

 Hi Kevin,

Russian Siemens SBT support claims that it is possible to connect directly (using Modbus TCP/IP protocol). Going to test it in several weeks! 

DeLaatKoudetechniek_Kevin

Hi,

Directly out of the climatix controller is not possible, There has to be a interface protocol...