Dear Expert,

I have the very similiar problem with Habbeh.

CU310-2 PN:  6SL3040-1LA01-0AA0

F30600, ...Remedy:

1- select Safe Torque Off and deselect again.

2- carry out a POWER ON (switch-off/switch-on) for all components.

3- replace the Motor Module involved.

4-For fault value = 1005: deactivate terminals STO_A/STO_B on the Power Module (set both DIP-switches to "OFF") or enable the "STO via terminals at the Power Module" function.

My additional questions: 1) how to select STO and then deselect it? 2) where is the DIP switches on Power Module? (I couldn't get the exact layout for this drive)

Thank you very much for your time and response in advance.  -xuejunliu

Habbeh

according to our line we have wire drawing machine, in this machine was installed nine power module Sinamics S120 with tow control unit 320. the faults coming is F01600 and F30600, and no reset just when switch power (OFF/ ON) then fault disappear and line run, may be after 15 min. fault appear. can any baody tell me how can remove these faults

------------------------------------------------------------------------------------------
Split from S120 fault f30600, f30611, f01600, and f01611 .