SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

MS300 EPROM for Technology Board T300

3/11/2010 9:56 AM	Rate (0)
Selvakumar Posts: 4 Rating: (0)	Dear All, Recently we have procured 3nos spare MS300 EPROM for T300 Technology Board. All 3 are for different type of gears, traversing, holding & closing. The existing version is V1.2 but the delivered version is 1.21. What I understand is, we have to plug the new EPROM on the T300 boards and download the T300 parameters. Once complete downloading the system should able to operate in normal condition. But when we tested the system after downloading, found there were fault occur. What could be the reason & is there any changes need to be done due to the upgraded version? Could anyone please advice & assist me on this.
Selvakumar Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

9/14/2011 6:25 PM	Rate (0)
Murali S Posts: 2 Rating: (0)	We are facing problem similar to this.After changing MS300 (HOLDING GEAR) we are downloaded program backup. but while running F0116 fault is coming.and we are not able to run the crane. Please anybody can support???
Murali S Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

11/15/2011 6:47 AM	Rate (0)
acabhi Posts: 6 Rating: (0)	Dear, Can somebody can support on this issue.. Any specific procedure other than downloading the same program while replacing MS300 for holding amd closing gear...
acabhi Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

7/10/2025 8:48 AM	Rate (0)
Ganesh Sachi Member Joined: 10/2/2016 Last visit: 7/16/2025 Posts: 9 Rating: (0)	can anyone tell me how to download parameters to T300 Board using siemens drive monitor?
	Thank and regards Ganesh Sachi
Suggestion To thank Quote Answer

Share this page:

Share this page on...