SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Change CUD board in the DC MASTER

3/26/2014 3:00 AM	Rate (0)
EdFranco Posts: 3 Rating: (0)	Good Night! In my job We have a DC Master (6RA7075 - 6DV62-0) and yesterday i needed install the (6RA7078-6DV62-0) in the same position. What kind of parameters i need change in relation of the MLFB, because I prefer use the same CUD. Thank's Edson A. Franco
EdFranco Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/26/2014 4:02 AM	Rate (1)
KSN Platinum Expert Joined: 8/25/2006 Last visit: 9/12/2025 Posts: 2218 Rating: (282)	Hello. You need not change CUD1 board, as it does not contain parameters. If your motor remains the same you can upload parameter set from old drive and download to the new drive. But pay attention to reducing rated converter currents in P076. Also check that optimization of all controllers are ok, if not execute optimization runs.

Suggestion To thank Quote Answer

3/26/2014 11:27 PM	Rate (0)
EdFranco Posts: 3 Rating: (0)	Hi! Thank's! But if i have a backup of the parameters the some DC MASTER with a type of MLFB and i need to download in other DC master with diference MLFB, the download of the parameters will be accepted? Because if not i will need to change? Thank you very much!
EdFranco Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/27/2014 4:31 AM	Rate (0)
KSN Platinum Expert Joined: 8/25/2006 Last visit: 9/12/2025 Posts: 2218 Rating: (282)	Hello. Parameters are stored on the board A7005, installed on the Simoreg door. Several parameters are display parameters (read-only) and could not be changed, also r070 (MLFB-number), so I think the download will be accepted.

Suggestion To thank Quote Answer

3/27/2014 11:52 PM	Rate (0)
EdFranco Posts: 3 Rating: (0)	Hi! Ok thank's
EdFranco Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

4/26/2018 12:04 AM	Rate (0)
ETTAHRIOUI Posts: 25 Rating: (1)	Non messieurs les paramètres sont installés sur la carte Eprom A7009 .
ETTAHRIOUI Posts: 25 Rating: (1)
Suggestion To thank Quote Answer

4/26/2018 12:05 AM	Rate (0)
ETTAHRIOUI Posts: 25 Rating: (1)	ETTAHRIOUI Les paramètres sont installés sur la carte Eprom A7009.
ETTAHRIOUI Posts: 25 Rating: (1)
Suggestion To thank Quote Answer

Share this page:

Share this page on...