Hello,

I'm trying to interconnect parameter r61(CO: Actual speed unsmoothed) from an encoder module SMC30 to DCC Chart that I create. On Expert list in Online mode I can read correct the rpm values from encoder, but in CFC editor the interconnected r61 value that i read in Test mode is different than before.

r61 parameter connected to multiplier in DCC.

Any help?

Thanks,

and in parameter p2000 which value should I put? the PPR of the encoder?

Thanks

So, I can't change that value.

In my case p2000 (r2700) is 3000.00 and even if multiply r2700 with r61 the rpm in dcc chart is not correct.

Thanks

Hi,

What do you mean timeslot?

The monitoring cycle is 1sec.

if you mean "cycles of the execution group", I use BEFORE speed setpoint channel

Thanks