Good evening forum

Im programming a servodrive from tiaportal v13 and when i go on to manual jog (picture) it tells me that i cant do that because its being controlled by the cpu but when i stop the cpu it tells me i cand manual jog because the cpu is in stop mode, Does anyone know how to make it work

P.s i got it to work twice but just mashing buttons

Hello,

Servo drive needs drive enable, pulse enable & set point commands in order to move. So please check if these commands are applied to servo drive, either in CPU or in manual mode.

HTH. 

PISCEAN 2010

Hello,

Servo drive needs drive enable, pulse enable & set point commands in order to move. So please check if these commands are applied to servo drive, either in CPU or in manual mode.

HTH. 

 I already have the funtion blocks put in the project with the ready and the jog funcions connected to the servo drive as displayed in the attachment, i did it again last night where i just keep on pressing take control 100 times and then it connects, i know its not meant to be like this so i guess im doing something wrong :/

Hi!

Try to disable the MC_Power block in your program when using the Commissioning page/jog.

Kahl

Hi!

Try to disable the MC_Power block in your program when using the Commissioning page/jog.

 Oke Kahl ill give it a go, im going to be here all day programing trying to move this machiene and measure its movement so ill check back and let you know how i got on soon