Skip to Content

Register Login

工业业务领域支持中心

Technical Forum

Navigation

G120 Drive F8501

Created by: vishu7861 at: 6/22/2022 4:43 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/22/2022 4:43 AM	Rate (0)
vishu7861 Member Joined: 9/6/2021 Last visit: 6/22/2022 Posts: 1 Rating: (0)	Hii sir i am using the g120 drive ,drive running mode then automatic drive tripe F8501 pls if any suggestion ------------------------------------------------------------------------------------------ Split from Drive tripped on F 8501 fault.
	Last edited by: Jen_Moderator at: 06/22/2022 11:30:41 New subject after splitting
Suggestion To thank Quote Answer

6/22/2022 7:32 AM	Rate (0)
PISCEAN 2010 Diamond Member Joined: 4/23/2010 Last visit: 8/9/2022 Posts: 7672 Rating: (767)	vishu7861 Hii sir i am using the g120 drive ,drive running mode then automatic drive tripe F8501 pls if any suggestion Hello Vishnu, Welcome to forum. F08501 - Setpoint time out. So check if PLC or controller is in STOP mode, interfacing communication cable, connector etc. etc.

Suggestion To thank Quote Answer

6/22/2022 7:38 AM	Rate (0)
Hati Platinum Member Joined: 9/21/2012 Last visit: 8/10/2022 Posts: 3346 Rating: (368)	vishu7861 Hii sir i am using the g120 drive ,drive running mode then automatic drive tripe F8501 pls if any suggestion The answer is: No connection between I/O controller and the G120. Usually it's a cable problem, if the PLC is in RUN.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on