SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Supplying manual setpoint from DCC chart

2/20/2009 2:18 PM	Rate (0)
sistarter Posts: 6 Rating: (0)	has anyone supplied the setpoint from within DCC chart for SINAMICS S 120 drives. I want to configure the manual setpoint from within DCC itself rather than sending from PLC.
sistarter Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

2/23/2009 9:46 PM	Rate (0)
Drives_Coach Posts: 133 Rating: (13)	Hello, If you are just writing logic in the DCC charts and sending to the speed setpoint this should be no problem. Attached is a sample DCCchart where I had two analog setpoints and I used binary switches to choose the setpoint going to the ramp generator. Attachment Chart.pdf (463 Downloads)
Drives_Coach Posts: 133 Rating: (13)
Suggestion To thank Quote Answer

2/24/2009 8:48 AM	Rate (0)
sistarter Posts: 6 Rating: (0)	thank you very much for the relpy. infact i had done something similar but where i am facing a problem currently is in directly being able to read a spare word on the telegram PZD which is in my case is being relased by a PLC. so i avail the option of run time execution after IF1 PZD word to ensure the spare control word is released. this initialyy is nothing but an enable to a DCC chart FBD which manually configures the setpoint. any idea how i can read an entire space word into a DCC chart address connection because when i open the connect to menu i do not see any parameters for the PZD telegram or i must have faltered in my approach somewhere.
sistarter Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

Share this page:

Share this page on...