Hello alanisgp,

You have also FM350 modules!
Very interesting!

For counter modules, we have the same procedure:
It is important that all Counter modules, which are used into the Hardware Configuration, are also called in the CFC plans.

You wrote:
“In other words, I have to change CoNo from 1 to 2, has to be equal to En_Co?”

No, check the following please:

1.
All Counter modules, which are used into the Hardware Configuration, have also to called in the CFC plans.
That’s important not only for the Siwarex modules, but also for the Counter modules!

2.
Which PCS7 version do you have?
Use the current driver for the Counter modules (e.g. don’t use V6 Counter module drivers in PCS7 V8).
That’s also important!

3.
If the Siwarex and Counter modules in the Hardware Configuration are equal to the CFC plans:
Go to the block “FM_CO” (= “SiwaU08” block: parameter “En_Co” goes to the block “FM_CO”).
Here you can find the input-parameter “ACC_ID”. Set this parameter to TRUE (= Reset the “FM_CO” block).
Is the parameter “En_Co” now changing at the “SiwaU08” block?




Best regards

Siwarexi