Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Link WinCC 6 to S7 PLCSIM

Created by: anh at: 12/17/2005 4:43 AM (3 Replies)

Rating (0)

Thanks 1

4 Entries

12/17/2005 4:43 AM	Rate (0)
anh Posts: 1 Rating: (0)	Hello I try to link WinCC 6.0 to S7 PLCSIM 5.2. What is a problem when communication/connection PLCSIM 5.2 with WinCC 6 SP1. In WinCC Channel Diagnostic, the state of connection always is "disconnected": First Error Code : D402 Last Error Code : D402 Thanks for response.
anh Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

12/17/2005 8:05 AM	Rate (0)
Essam Posts: 47 Rating: (0)	I have used the plc sim v5.2with wicc v6.0 & thos is the stipes. 1-stars S7 SIMATIC Manager. 2-start PLC-Sim. 3- uplode your program to the PLC-Sim. 4- Start wincc 5- setup the connection & triy to chik hands 6-run wincc progect thanks ESB
Essam Posts: 47 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Saruca

1/23/2006 5:58 PM	Rate (0)
Reuben Posts: 70 Rating: (13)	Hi Check version compatibility - you may need PLC-SIM V5.3 with WinCC V6.0 onwards. I remember I had a problems with PLC-SIM and WinCC, but I can't remember what versions. Reuben
Reuben Posts: 70 Rating: (13)
Suggestion To thank Quote Answer

1/23/2006 6:21 PM	Rate (0)
Freddy Experienced Member Joined: 9/13/2005 Last visit: 11/18/2019 Posts: 86 Rating: (10)	Hi! make sure that you have created aMPI connection: http://support.automation.siemens.com/WW/view/en/21914005
	Last edited by: Freddy at: 1/23/2006 6:22 PM Best Regards - Mit freundlichem Gruß - yoroshiku onegaisimasu - Sincères salutations -Freddy- [8)]
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on