Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

MM440 ON Line communication with PG

Created by: Sdd at: 7/16/2007 9:42 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

7/16/2007 9:42 AM	Rate (0)
Sdd Posts: 14 Rating: (0)	Hi, I have been using drive monitor for communication between PG and MM440. However I am unable to upload the program from MM440 to PG with MM440 V2.1.I do not have drive monitor consisting of V2.1. I also tried to establish communication on Starter ES software but unable to go online despite selecting the USS protocol in the PG/PC Interface. Can anybody guide me as to how to get Drive monitor with MM440 V2.1 & establish communication on Starter plateform? Thanks, SDD
Sdd Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

7/16/2007 1:16 PM	Rate (0)
miami Platinum Member Joined: 8/31/2005 Last visit: 11/13/2024 Posts: 2198 Rating: (328)	Try this: http://support.automation.siemens.com/WW/view/en/22813212

Suggestion To thank Quote Answer

7/18/2007 10:04 AM	Rate (0)
Sdd Posts: 14 Rating: (0)	Hi, MM440 is not configured with profibus & PLC.Its a simple stand alone MM440 drive V2.1. I need to connect the same to PG using either the drive monitor or the starter software & upload the complete drive parameters. SDD
Sdd Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

8/4/2007 3:38 PM	Rate (0)
Sdd Posts: 14 Rating: (0)	Hi, I want to upload the drive parameters using drive monitor.I do not have MM440 V2.1 installed in my PG.Where ca I get this software. SDD
Sdd Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on