Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Pid help

Created by: zifzaf at: 4/2/2011 9:58 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/2/2011 9:58 AM	Rate (0)
zifzaf Experienced Member Joined: 7/8/2010 Last visit: 10/1/2018 Posts: 19 Rating: (1)	hello After almost a week of trying .no way for meto get the pid working in s7-1200 1212c. anyone can help me i wanna use input_PER fom IW 64 , and output_PER FROM QW80 signal board. i have put the pid inside OB200 the aplication i m trying to use pid for is controling of VFD for water pump using analog out. i c an see the iw64 analog value , but nothing comming out of Q80. i have downloaded the pid examples on this forum but this could not help. thanks in advance
	Last edited by: zifzaf at: 4/2/2011 10:09 AM
Suggestion To thank Quote Answer

4/2/2011 4:04 PM	Rate (0)
Marko Bursic Platinum Member Joined: 9/8/2009 Last visit: 7/17/2023 Posts: 1410 Rating: (153)	Have you configured OB200 as CyclicInterrupt organization block?

Suggestion To thank Quote Answer

4/4/2011 11:56 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 11/4/2024 Posts: 4351 Rating: (1451)	Hi, take a look also in the tips: Tips: PID (FB PID_Compact) /tf/WW/en/Posts/33957#top Extra tip: maybe your problem is just a question of tho take out of manual operation mode.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on