Simovert Compact errors when downloading parameter file

I have a continuous issue whenever I try and download parameters to (seems like) any Simovert Masterdrives Compact Plus unit. Here is what happens: I connect to Drive Monitor and use the "save drive parameters to file" button to save to my computer. However, even without changing a single thing at that point, if I THEN go to "download parameter file to drive", I almost always get a whole slew of errors during the process. Then when it asks if I'd like to retry, I'll do it again, and the same thing will happen, and the number of errors will change.

Sometimes, if I do it a second or third time, it will just go through with zero errors. Sometimes it will just keep going in this cycle and never end. Sometimes I'll get an unrecognized device error. Throughout the process, I will keep seeing the "Device Identification" box pop up, and it seems like at this moment is when the errors start racking up.

What is causing this with every single drive? I had asked something similar to this years ago and was told to make sure P070 matches the model number, but it always does, and this still happens.

Graeme

 Hi Waldo924,

You don't mention what drive part number/firmware versions you are using.

Do you have your original parameter file from the OEM?

Can you look and see what was in parameter P053?

Are you able to change P060 = 7 or is it forced back to 0?

Regards,

Graeme

 Hi Graeme,

Currently I'm getting this on a 6SE7016-0TP50, but it happens in nearly every single Compact Plus unit I've worked on for the past 10 years.

We don't have any original OEM files, what we save is whatever the customer had programmed. Then we default the unit, recommission to run in our system, and if all tests well, we reload the customer's file and always run into this.

Currently, P053 on this one shows 0000000001111111.

P060 does go back to 7, but sometimes it seems like it locks into a the loop described above until it accepts me pressing "Cancel".

 Dear Graeme and Team,

I am Facing Same Problem while downloading.

I have P053=0000000000000111

P060=6(download). I also tried using 7 but failed.

I am Facing F029 Fault and tried to change CUVC(not new) from another running drive . When I tried downloading backup parameter(complete), I got Similar message(452 rejected of 913).

Need Help Urgently.

Waldo924

 

Graeme

 Hi Waldo924,

You don't mention what drive part number/firmware versions you are using.

Do you have your original parameter file from the OEM?

Can you look and see what was in parameter P053?

Are you able to change P060 = 7 or is it forced back to 0?

Regards,

Graeme

 Hi Graeme,

Currently I'm getting this on a 6SE7016-0TP50, but it happens in nearly every single Compact Plus unit I've worked on for the past 10 years.

We don't have any original OEM files, what we save is whatever the customer had programmed. Then we default the unit, recommission to run in our system, and if all tests well, we reload the customer's file and always run into this.

Currently, P053 on this one shows 0000000001111111.

P060 does go back to 7, but sometimes it seems like it locks into a the loop described above until it accepts me pressing "Cancel".