Timers

Good after noon folks, 

Its been a while since I have used Logo most of it is coming back to me however i'm looking to use a Logo to control some motors now i'm looking to duty cycle two sets of motors. 

So what i'm looking to do is use 1 relay "Q1" to close for a set time then open for a set time this will then control one pump

Then using "Q2" I would control the other pump so when Q1 is closed pump 1 is running and once the timer expires then pump 2 would take over until the timer expires and then it would revert back to pump 1 and so forth

The other thing that would be good is if the signal was taken away from the input it would pause the timer.

All help is appreciated 

nDabbers

The other thing that would be good is if the signal was taken away from the input it would pause the timer.

With the quoted design requirement in mind..
See the attachment suggestion.
^{// Logo! V8.0 and higher assumed
// Room is left for optimization and improvement}

 Would you be a blessing to send or post a working copy that i could download and use to suit my requirements please, you have been most helpful.

qwazee

 

nDabbers

The other thing that would be good is if the signal was taken away from the input it would pause the timer.

With the quoted design requirement in mind..
See the attachment suggestion.
^{// Logo! V8.0 and higher assumed
// Room is left for optimization and improvement}

nDabbers

 Would you be a blessing to send or post a working copy that i could download and use to suit my requirements please, you have been most helpful.

 Attached

That works an absolute treat thank you so much.

ATB 

Neil