Navigation
1214C, CM1241 RS232 with third party servodrive by using modbus
Created by: prasadK at: 7/11/2015 10:53 AM (0 Replies)
Rating 
Thanks 0
1 Entries
| 7/11/2015 10:53 AM | |
|
Posts: 1 Rating:
|
hi.. Please any one help me.. I'm using Modbus module CM1241 RS232 with CPU Siemens 1214C. How can i communicate Siemens CPU with third party servodrive(not siemens servodrive) by using modbus. I'm totally blank about modbus so please tell me which instructions/settings should i use in TIA V13? I have to give ten differernt positions to servo motor through PLC. Total number of drives are four. rgds Prasad
---------------------------------------------------------------------------------------------------- |
Last edited by: Min_Moderator at: 7/13/2015 1:43:07 PMNew subject after splitting |
|
Follow us on