Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Contact wheel encoder

Created by: 3lvis at: 8/7/2024 6:04 AM (2 Replies)

Rating (1)

Thanks 2

3 Entries

8/7/2024 6:04 AM	Rate (0)
3lvis Member Joined: 7/10/2020 Last visit: 10/10/2024 Posts: 2 Rating: (0)	Hi. I have an issue when I tried to replace an encoder in a project. The costumer replaced the encoder 6FX2001-5QD13-0AA1 for a 6FX2001-5QD13-1AA0. The system (MC) runs on Simotion V5.2 and this axis is controlled by a extension CX32-2 (Control_Unit.Closed-loop control module 1 5102302 Closed-loop control module 6AU1432-2AA00-0AA0 G ST-M76031104 ) At first I thought it was only firmware incompatibility, but the fault remedy don't mention it. I got the following message: F07552 (A) Drive encoder: Encoder configuration not supported V05.10

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Moderator_Lan

8/7/2024 11:30 AM	Rate (1)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/8/2024 Posts: 5935 Rating: (815)	Hello, there are differences between the encoders. DRIVE-CLiQ Synchrofl. VW 6mm 22 bit RJ45 (6FX2001-5FD13-0AA1) https://support.industry.siemens.com/cs/ww/en/pv/6FX2001-5.D.../pi?dl=de DRIVE-CLiQ Clamp fla. VW 10mm 24 bit M12 6FX2001-5QD13-1AA0 https://support.industry.siemens.com/cs/ww/en/pv/6FX2001-5QD13-1AA0/pi It is necessary to read out the encoder to get the right configuration in your project. 22Bit versus 24 Bit. P400 = 10000
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users 3lvis

8/7/2024 12:06 PM	Rate (0)
3lvis Member Joined: 7/10/2020 Last visit: 10/10/2024 Posts: 2 Rating: (0)	Thanks for the support.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on