Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Advice for Siemens Load Cell Calibration

Created by: ni1 at: 5/11/2011 5:57 PM (12 Replies)

Rating (0)

Thanks 1

Result pages:: |; 1 | 2; |

13 Entries

Entries per page: 10 | all

5/20/2011 4:56 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Siwarexi ... Some questions to UMENCHO: 1. What do you mean with “some offsets in measurement” ? Siwarexi Isn't be a true that if I didn't make a "Adjustment Weight Valid" I will have some error between measured weight and phisical one there? Siwarexi 2. What do you mean with “SPAN calibration” ? ... Siwarexi I meant Adjustment Weight Valid. Thank you! Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

5/23/2011 10:15 AM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 10/15/2024 Posts: 1147 Rating: (175)	Hello UMENCHO, You are right. If you are doing a calibration, you have to execute the commands “Adjustment zero valid” AND “Adjustment weight valid”. If you don't execute these two commands, you will not see the correct weight value. Best regards Siwarexi

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users UMENCHO

5/23/2011 12:15 PM	Rate (0)
ni1 Posts: 50 Rating: (0)	Dear All, Now I have already done loadcell calibration correctly. Thanks all for yours valuable inputs. Best Regards, Ni
ni1 Posts: 50 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on