Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Using a LOGO! Analogue output as a reference supply

Created by: peter_490 at: 3/24/2025 2:11 PM (4 Replies)

Rating (0)

Thanks 2

5 Entries

3/24/2025 2:11 PM	Rate (0)
peter_490 Joined: 2/18/2025 Last visit: 4/26/2025 Posts: 6 Rating: (0)	Sirs, I am in need of a 10 volt reference, can I use a LOGO!'s spare analogue output to provide this? - the resulting analogue will be fed back into the LOGO!s input.
	Last edited by: peter_490 at: 03/24/2025 14:22:15
Suggestion To thank Quote Answer

3/24/2025 4:03 PM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 9/7/2025 Posts: 35933 Rating: (4498)	It's not entirely clear what you mean by "LOGO!'s spare analog output." A LOGO! doesn't have a physical analog output, only the AM2 AQ analog expansion module. If that's not what you mean, then you'll need to explain in more detail what you mean.

Suggestion To thank Quote Answer

3/24/2025 5:00 PM	Rate (0)
peter_490 Joined: 2/18/2025 Last visit: 4/26/2025 Posts: 6 Rating: (0)	Sirs, thank you for your reply, yes, I would be using an AM2 AQ analogue module.
	Last edited by: peter_490 at: 03/24/2025 17:01:34
Suggestion To thank Quote Answer

3/24/2025 5:04 PM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 9/7/2025 Posts: 35933 Rating: (4498)	I think that would be possible.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users peter_490

3/24/2025 6:02 PM	Rate (0)
peter_490 Joined: 2/18/2025 Last visit: 4/26/2025 Posts: 6 Rating: (0)	Sirs, Thank you for your confirmation, Kind regards, Peter

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ixo65

|

Share this page:

Share this page on...

Follow us on