Have to commission Sinamics each time it turns off???

Hey guys.

So I have 5 non-Siemens motors in parralel connection and to run them I have to first identify those motors and then change parameter p10 to [0]Ready. After that my motors can run. But the problem is that after the work day the cabinet is switched off and then in the morning I have to again do Identification and changing of the parameter p10. That is OK now when I am commsiioning the system, but when I leave the workers here must run the system without doing that. How can I make my drive remember that I commsioned it and not need set up from Starter each time I turn off the system?

Thanks.

1. I did identification of the motor parameters1

2. Put p10 to 0

3. Ram to Rom still greyed out, so pressed load project to target system

4. After I did that and it loads, p10 returns to 1???

Are you sure you have your CU selected in STARTER not any other object ?

F.e you can download parameters having "configure_drive_unit" selected, but copy ram to ram would be disabled.